Show Dot1X Counter - Allied Telesis SwitchBlade x3100 Series Manual

Configuring Port Authentication

SHOW DOT1X COUNTER

Syntax
SHOW DOT1X COUNTER [INTERFACE={type:id-range|id-range|ifname-
list|ALL}] [SUPPLICANT=macaddress-list|ALL]
[TYPE={STATISTICS|DIAGNOSTICS|SESSIONSTATISTICS|ALL}] [FULL]
This command is used to display the counters/statistics of supplicants which have been
Description
authorized by 802.1X-based Port Authentication.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
SUPPLI-
CANT
TYPE
FULL
Example
SHOW DOT1X COUNTER
--- Port Authentication Statistics Counters ---
ETH:6.22 : 00:09:41:58:E6:F2
---------------------------
EAPOL
EAP Resp/Id
--- Port Authentication Diagnostics Counters ---
ETH:6.22 : 00:09:41:58:E6:F2
---------------------------
[Connecting]
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
The ethernet interfaces over which the authentication
parameters will be shown.
Specifies a supplicant's MAC address or ALL supplicants.
The type of Counter
STATISTICS - statistics counters are displayed.
DIAGNOSTICS - diagnostics counters are displayed.
SESSIONSTATISTICS - session statistics counters are
displayed.
ALL - All types are displayed
Displays more descriptive information
Rx Tx
2 19
Response Req/Id Tx
0 2
[Authenticating]
Start Logoff
0 0
Req Tx
0 19
[Authenticated]
Introduction
Default Value
ALL
ALL
ALL
Abbreviated
Invalid
0
LenErr
0
[Backend]
6-129