Allied Telesis SwitchBlade x3100 Series Manual page 423

Configuring BPDU Cop
DISABLE STP
Syntax
DISABLE STP
[ { [ INSTANCE={ stpname | mstid | MAIN | ALL }
INTERFACE={ type:id-range | id-range | ifname-list | ALL }
[ TOPOLOGYCHANGE ] ] |
[ INTERFACE={ type:id-range | id-range | ifname-list | ALL } [
TOPOLOGYCHANGE ] ] } ]
Disables Spanning Tree Protocol operations for the system. When this command is
Description
issued, all ports in the system are set to the STP FORWARDING state so that they are
traffic capable. The STP port state displayed for all ports is STP DISABLED to indicate
that STP operations are disabled.
The following table gives the range of values for each option that can be specified with
Options
this command and a Default Value (if applicable).
Option
INSTANCE
INTERFACE
TOPOLO-
GYCHANGE
Example
(Disable instance on all interfaces)
officer SEC>> disable stp int all
Spanning Tree Protocol operation is now disabled for the specified interface/
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Description
The instance to be disabled.
The interface(s) on which STP will be disabled.
Controls the detection of topology changes on the
associated port. This allows the disabling of topology
change detection on ports that are known to be con-
nected to single end stations that could cause the Topol-
ogy Change Notification mechanism to be triggered for
the entire network when the end station is power
cycled.
interface-list (0-3,6-7,9-11.0-3,8.0-23)
Introduction
Default Value
4-103