Allied Telesis SwitchBlade x3100 Series Manual page 661

Configuring Port Authentication
TABLE 6-19
Step Command
Set interim update to ON, and change accounting period to 60. (Refer to
SET RADIUS ACCOUNTINGPERIOD=60 INTERIMUPDATE=ON
5
Display RADIUS configuration.
SHOW RADIUS
6
--- RADIUS --------------------------------------------------------------------
Auth Mode............................. Login
Interim-Update........................ ON
Accounting Period..................... 60
RADIUS Servers ------------------------------------------------------------
Hostname/IP
Address
---------------- -------- --- ----- ----- ------- ----- ---------------- -----
192.168.10.205
192.168.10.206
192.168.10.207
Enable 802.1X for the SBx3112.
ENABLE DOT1X
7
Enable 802.1X for the specific interfaces.
ENABLE DOT1X INTERFACE=6.22-6.23
8
Start accounting using the parameter STARTSTOP, so a START accounting message is sent at the beginning of a session
and a STOP accounting message is sent at the end of a session.
Ensure the RADIUS server(s) also have the accounting option enabled. Refer to Step 4.
Note:
SET DOT1X ACCOUNTING=STARTSTOP
9
SHOW DOT1X
--- Port Authentication Information ---
802.1X
------
802.1X Port-Based Authentication...... Enabled
RADIUS Accounting...................... Start-Stop
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Configuration procedure for Port Authentication
Auth Acct
Status Pri Port Port
Enabled 1 1812 1813
Enabled 2 1812 1813
Enabled 3 1812 1813
Description
SET RADIUS AUTHMODE
Time
Retries out Function
2 5 AUTHENTICATION,
ACCOUNTING
2 5 AUTHENTICATION,
ACCOUNTING
3 5 AUTHENTICATION,
ACCOUNTING
Introduction
(SEC).)
Type
LOGIN
,DOT1X
LOGIN
,DOT1X
LOGIN
,DOT1X
6-101