Add Pvc Destination; Cro: Create Out Vc In Call - 3Com CoreBuilder 9000 User Manual

Add PVC Destination

Create an additional destination connection (branch) for an existing
point-to-multipoint PVC.
You can only create an additional destination if the existing PVC was
predefined as a PLM PVC.
Enter the call number of the original PVC setup and the parameters:
output port number, VPI/VCI and CLP, with the same permissible values.
Default values for Cell Loss Level, Priority, and Cell Loss Priority are used.
See Table 23. The same limits as full PVC call setup apply.
You cannot add an additional PVC destination to a P2P PVC.
Command Actions
Enter the menu sequence: (3) CON: Connections
Enter a parameter at the prompt
Parameter
Call number
Output port number
Output port VPI
Output port VCI
Output port CLP
Direct access sequence:
Create Permanent Virtual Channel (PVC)
(4) S&C: Setup of Connections and ATM
Addresses
(1) PVC: PVCs Setup
(1) GET: Display VPI/VCI Limits

(4) CRO: Create out VC in call

Format or Range
Integer
<slot.group.port>
See (3)CON\(4)S&C\(1)PVC\(1)GET for VPI/VCI
limits
See (3)CON\(4)S&C\(1)PVC\(1)GET for VPI/VCI
limits
0 for clear
1 for set
3 4 1 1 4 [parameters]
173