Info-Center Loghost Source; Info-Center Monitor Channel - H3C s3600 series Command Manual

Be sure to set the correct IP address in the info-center loghost command. A loopback IP address will
cause an error message, prompting that the address is invalid.
Related commands: info-center enable, display info-center.
Examples
# Configure the system to output system information to the Unix log host whose IP address is
202.38.160.1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center loghost 202.38.160.1

info-center loghost source

Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
Parameters
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
Description
Use the info-center loghost source command to configure the source interface through which
information is sent to the log host.
Use the undo info-center loghost source command to cancel the source interface configuration.
Related commands: info-center enable, display info-center.
Examples
# Configure VLAN-interface 1 as the source interface through which information is sent to the log host.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center loghost source Vlan-interface 1

info-center monitor channel

Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
1-10