Configuring A Pos Subinterface; Configuring A Pos Channel Interface - H3C SR6600 Configuration Manual

Step
23. Shut down and bring up the
interface.

Configuring a POS subinterface

Step
1. Enter system view.
2. Create a POS subinterface
and enter its view.
3. Configure the subinterface
description.
4. Set the MTU.
5. Configure the expected
bandwidth of the
subinterface.
6. Restore the default settings
for the POS subinterface.
7. Shut down and bring up the
POS subinterface.

Configuring a POS channel interface

POS channel interfaces are created through channelization of a high-speed CPOS interface. They
work in the same way as POS interfaces. For more information about creating POS channel
interfaces, see
To configure a POS channel interface:
Step
1. Enter system view.
2. Enter POS channel interface
view.
3. (Optional.) Configure the
interface description.
Command
shutdown
undo shutdown
Command
system-view
interface pos
interface-number.subnumber
[ p2mp | p2p ]
description text
mtu size
bandwidth bandwidth-value
default
shutdown
undo shutdown
"Configuring CPOS interfaces."
Command
system-view
interface pos interface-number
description text
30
Remarks
By default, a standard POS
interface is up.
For the settings to take effect, you
must perform this step.
If no cable is connected to the
interface, shut down the interface
to prevent interface exceptions.
Remarks
N/A
You can create POS
subinterfaces only on Frame
Relay-enabled standard POS
interfaces.
By default, the description of a
POS subinterface is interface
name Interface, for example,
Pos2/1/1.1 Interface.
The default setting is 1500 bytes.
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided by
1000.
N/A
By default, a POS subinterface is
up.
For the settings to take effect, you
must perform this step.
Remarks
N/A
N/A
By default, the description of a
POS channel interface is interface
name Interface, for example,
Pos2/1/1:0 Interface.