Connecting The Cable And The Wall Sockets To The Internal U P0 Port - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Installation and Commissioning

ISDN End Devices

Connecting the Cable and the Wall Sockets to the Internal U

Warning: Power surges, which can occur during electrical storms, can

cause life-threatening electric shocks or damage or destroy the PBX.

• Hire a qualified electrician to lay the cables within the building.

Note: For a structured cable installation configured on the COMpact

5000R, CAT 5 cables and CAT 5 wall sockets are used instead of the

cables and wall sockets listed here. To connect an analogue device, a

commercially-available RJ-45/TAE adapter is required.

Important: For a structured cable installation on the COMpact 5000R, the

line length of all applicable end devices must be taken into account.

1. Lay the line.

Note: Prevent interferences. Avoid laying long lengths of parallel lines,

especially next to mains. Twist the pairs.

2. Attach the wires to the two central terminal clamps at the internal U

3. Make the connections:

• ISDN wall socket: Connect the IAE or UAE8 sockets to the terminal clamps at the

• Connect the U

adapter: Connect the two screw terminals on the back of the U

adapter to the terminal clamps of the internal U

adapter, if necessary.

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Compact 5000r