Honda Accord 2008 Manual page 2018

07/11/02 09:44:37 61TA0000_210_0154
10. Check for continuity between body ground and the
passenger's climate control switch 12P connector
terminals as shown.
＊０３
PASSENGER'S CLIMATE CONTROL SWITCH
12P CONNECTOR
Is there continuity?
YES
between the driver's climate control switch and the
passenger's climate control switch.
NO −
control switch, and recheck. If the symptom goes
away, replace the original passenger's climate
control switch (see page 21-165).
LT BLU
YEL WHT ORN BRN LT GRN
Wire side of female terminals
−
Repair short to body ground in the wire(s)
Substitute a known-good passenger's climate
11. Disconnect the driver's climate control switch 16P
connector.
12. Turn the ignition switch to ON (II).
13. Measure the voltage between body ground and the
driver's climate control switch 16P connector
No. 11 terminal.
DRIVER'S CLIMATE CONTROL SWITCH 16P CONNECTOR
LT GRN
Wire side of female terminals
Is there battery voltage?
YES − Go to step 14.
−
NO Repair open in the wire between the driver's
climate control switch and the No. 16 (7.5 A) fuse in
the driver's under-dash fuse/relay box.
14. Turn the ignition switch to LOCK (0).
＊０４
(cont'd)
21-153