Suzuki Baleno Manual page 94

E. MAGNET CLUTCH
1. Armature plate
2. Screw 3. Washer
Inspection
1) Check pressure plate and rotor for wear and oil soaked condi-
tions respectively.
2) Check clutch bearing for noise, wear and grease leakage.
3) Measure stator coil for resistance at 205C (685F).
Standard Resistance: 2.9 – 3.8 W
If the measured resistance does not remain within above toler-
ance, replace coil.
Removal
1) Remove compressor. Refer to "A. COMPRESSOR" in this sec-
tion.
2) Fix armature plate with special tool (A) and remove armature
plate screw.
Special Tool
(A): 09991-06020
NOTE:
Do not reuse armature plate nut.
3) Using special tool (B), remove armature plate.
Special Tool
(B): 09991-06030
1. Armature plate
AIR CONDITIONING (OPTIONAL) 1B-29
1. Armature plate screw
2. Armature plate
3. Circlip
4. Magnet clutch
5. Washer
6. Shim
7. Oil felt ring
8. Magnet clutch coil
9. Lip type seal
10. Compressor front head
11. Compressor body assembly
12. O-Ring
13. Compressor thermal switch