Toyota Celica 2005 Repair Manual page 1931

SA−24
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
(e)
Matchmarks
NOTICE:
Do not punch the marks.
F02792
F02793
NOTICE:
Be careful not to damage the inner race.
(f)
NOTICE:
F02794
Do not disassemble the outboard joint.
2.
(a)
N00191
(b)
(c)
− FRONT DRIVE SHAFT
Disassemble the outboard joint shaft.
(1) Place matchmarks on the outboard joint shaft, inner
race and cage.
(2) Remove the 6 balls.
(3) Slide the cage toward outboard joint.
(4) Using a snap ring expander, remove the snap ring.
(5) Using a brass bar and hammer, remove the inner
race.
(6) Remove the cage.
Remove the dynamic damper (M/T), damper clamp (M/T),
inboard and outboard joint boots and inboard joint
clamps.
1ZZ−FE engine (A/T):
DISASSEMBLE DRIVE SHAFT
Check the drive shaft.
(1) Check to see that there is no remarkable play in the
outboard joint.
(2) Check to see that the inboard joint slides smoothly
in the thrust direction.
(3) Check to see that there is no remarkable play in the
radial direction of the inboard joint.
(4) Check the boots for damage.
Remove the inboard and outboard joint boot clamps.
(1) Using a screwdriver, disclamp the 2 inboard joint
boot clamps.
(2) Using a side cutter, cut the 2 outboard joint boot
clamps and remove them.
Remove the inboard joint shaft.
(1) Slide the inboard joint boot toward the outboard
joint.
1930