Toyota Celica 2005 Repair Manual page 1769

SST
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
3.
(a)
Case Side
NOTICE:
Be sure to install the vehicle speed sensor drive gear in the
correct direction, as shown in the illustration.
D08250
(b)
NOTICE:
When replacing the tapered roller bearing outer race, re-
place the tapered roller bearing along with it.
HINT:
Set SST to the bearing inner race securely.
D08251
4.
(a)
Case Side
(b)
(c)
(d)
HINT:
Align the matchmarks on the differential case and contact the
ring gear.
D07375
(e)
CAUTION:
The ring gear set bolts should not be tightened until the
ring gear has cooled sufficiently.
(f)
5.
NOTICE:
Perform this only when replacing the tapered roller bearing
and outer race of the differential case.
(a)
(b)
CM0061
− DIFFERENTIAL CASE
Vehicle speed sensor drive gear side:
INSTALL TAPERED ROLLER BEARING
Place the vehicle speed sensor drive gear in position to
stop it turning, and install the vehicle speed sensor drive
gear.
Using SST and a press, install a new side bearing.
SST 09316−60011 (09316−00011), 09350−32014
(09351−32120)
INSTALL RING GEAR ON DIFFERENTIAL CASE
Clean the contact surface of the differential case.
Heat the ring gear in boiling water.
Carefully take the ring gear out of the water.
After the moisture on the ring gear has completely evapo-
rated, quickly install the ring gear to the differential case.
Temporarily install the 8 set bolts.
After the ring gear has cooled sufficiently, torque the ring
gear set bolts uniformly at a time.
Torque: 77 N·m (790 kgf·cm, 57 ft·lbf)
INSPECT DIFFERENTIAL TAPERED ROLLER BEAR-
ING PRELOAD
Install the differential case assembly to the transaxle
case.
Install the transmission case to the transaxle case with
the 16 bolts.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
1768
MX−51