Toyota Celica 2005 Repair Manual page 2120

SUPPLEMENTAL RESTRAINT SYSTEM
Stripped Wire Harness Section
2005 CELICA (RM1131U)
(a)
CAUTION:
(b)
Connector
(c)
H03200
(d)
Wire Harness
Diameter
CAUTION:
If a wire harness which is too thin or some other thing is
used to tie down the steering wheel pad, it may be snapped
by the shock when the airbag is deployed. This is highly
dangerous. Always use a wire harness for vehicle use
AB0163
which is at least 1.25 mm
HINT:
To calculate the square of the stripped wire harness section:
L
NOTICE:
M
H03201
− STEERING WHEEL PAD AND SPIRAL CABLE
Remove the steering wheel pad (See page SR−13).
When removing the steering wheel pad, work must be
S
started 90 seconds after the ignition switch is turned
to the "LOCK" position and the negative (−) terminal
cable is disconnected from the battery.
When storing the steering wheel pad, keep the upper
S
surface of the pad facing upward.
Remove the connector on the steering wheel pad rear
surface.
Remove the steering wheel pad cover.
Using a service−purpose wire harness tie down the steer-
ing wheel pad to the disc wheel.
Wire harness: Stripped wire harness section
2
1.25 mm
or more (0.0019 in
Square = 3.14 x (Diameter)
(1) Install the 2 bolts with washers in the 2 bolt holes in
the steering wheel pad.
Bolt:
L: 35. mm (1.387 in.)
M: 6.0 mm (0.236 in.)
Pitch: 1.0 mm (0.039 in.)
Tighten the bolts by hand until the bolts become diffi-
S
cult to turn.
Do not tighten the bolts too much.
S
2119
2
. or more)
2 2
(0.0019 in .).
2
divided by 4
RS−19