Toyota Celica 2005 Repair Manual page 1761

Synchronizer
Middle Ring
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
HINT:
Take care not to damage the journal surface of the output shaft.
6.
7.
For 2nd Gear
(a)
(b)
(c)
NOTICE:
S
D07361
S
(d)
Synchronizer
Inner Ring
NOTICE:
Fit the synchronizer inner ring claws into the slots in the
No. 1 clutch hub.
D07362
(e)
NOTICE:
Be sure to install the 3rd driven gear in the correct direc-
tion, as shown in the illustration.
8.
D07363
− OUTPUT SHAFT
INSPECT 1ST GEAR THRUST CLEARANCE
(See page MX−36)
INSTALL SPACER, NEEDLE ROLLER BEARING,
NO. 2 SYNCHRONIZER RING, 2ND GEAR AND 3RD
DRIVEN GEAR
Install the spacer.
Apply gear oil to the needle roller bearing and install it.
Place the No. 2 synchronizer rings on the 2nd gear.
Properly fit the synchronizer middle ring claws into
the holes in the 2nd gear.
Distinguish the No. 2 synchronizer ring by the teeth
on the synchronizer ring.
Place the 2nd gear with the No. 2 synchronizer rings and
align the No. 2 synchronizer ring slots with the No. 1 shift-
ing keys.
Using a press, install the 3rd driven gear.
INSPECT 2ND GEAR THRUST CLEARANCE
(See page MX−36)
1760
MX−43