Toyota Celica 2005 Repair Manual page 1479

2005 CELICA (RM1131U)
ENGINE MECHANICAL −
19. CHECK CONNECTING ROD THRUST CLEARANCE
Using a dial indicator, measure the thrust clearance while mov-
ing the connecting rod back and forth.
Standard thrust clearance:
0.160 − 0.342 mm (0.0063 − 0.0135 in.)
Maximum thrust clearance:
0.342 mm (0.0135 in.)
If the thrust clearance is greater than maximum, replace the
connecting rod assembly(s). If necessary, replace the crank-
A01155
shaft.
Connecting rod thickness:
19.788 − 19.840 mm (0.7791 − 0.7811 in.)
20. REMOVE CONNECTING ROD CAPS AND CHECK OIL
CLEARANCE
(a) Check the matchmarks on the connecting rod and cap are
aligned to ensure correct reassembly.
(b) Remove the 2 connecting rod cap bolts.
A01156
(c) Using the 2 removed connecting rod cap bolts, remove
the connecting rod cap and lower bearing by wiggling the
connecting rod cap right and left.
HINT:
Keep the lower bearing inserted with the connecting rod cap.
A01157
(d) Clean the crank pin and bearing.
(e) Check the crank pin and bearing for pitting and scratches.
If the crank pin or bearing is damaged, replace the bearings.
If necessary, replace the crankshaft.
A01158
1478
CYLINDER BLOCK
EM−93