Toyota Celica 2005 Repair Manual page 1716

CL−16
5
3
2005 CELICA (RM1131U)
Q01057
Q06033
D00203
1
7
4
6
8 2
A01231
90°
Painted Mark
A01232
CLUTCH − CLUTCH UNIT
INSPECTION
1. INSPECT CLUTCH DISC FOR WEAR OR DAMAGE
Using vernier calipers, measure the rivet head depth.
Minimum rivet depth: 0.3 mm (0.012 in.)
If necessary, replace the clutch disc.
2. INSPECT CLUTCH DISC RUNOUT
Using a dial indicator, check the disc runout.
Maximum runout: 0.8 mm (0.031 in.)
If necessary, replace the clutch disc runout.
3. INSPECT FLYWHEEL RUNOUT
Using a dial indicator, check the flywheel runout.
Maximum runout: 0.1 mm (0.004 in.)
If necessary, replace the flywheel.
HINT:
The flywheel bolts are tightened in 2 progressive steps, (1) and
(3).
(1) Install and uniformly tighten the 8 mounting bolts, in
several passes, in the sequence shown.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
(2) Mark the flywheel bolt with paint.
(3) Retighten the flywheel bolts by an additional 90°.
(4) Check that the painted mark in now at a 90° angle
to (2).
1715
CL031−09