EM−108
(Cavity)
Front Mark
(Protrusion)
2005 CELICA (RM1131U)
ENGINE MECHANICAL
REASSEMBLY
HINT:
S
S
S
1.
(a)
HINT:
Be sure that end gap of the snap ring is not aligned with the pin
hole cutout portion of the piston.
A01193
(b)
80 − 90°C
A01187
(c)
(d)
A01186
(e)
HINT:
Be sure that end gap of the snap ring is not as aligned with the
pin hole cutout portion of the piston.
A01192
−
CYLINDER BLOCK
Thoroughly clean all parts to be assembled.
Before installing the parts, apply fresh engine oil to all slid-
ing and rotating surfaces.
Replace all gaskets, O−rings and oil seals with new parts.
ASSEMBLE PISTON AND CONNECTING ROD
Using a small screwdriver, install a new snap ring at one
end of the piston pin hole.
1ZZ−FE:
Gradually heat the piston to 80 − 90°C (176 − 194°F).
Coat the piston pin with engine oil.
Align the front marks on the piston and connecting rod,
and push in the piston with your thumb.
Using a small screwdriver, install a new snap ring on the
other end of the piston pin hole.
1493
EM165−05