Toyota Celica 2005 Repair Manual page 1920

Backlash: Deviation:
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
REMOVAL
1.
2.
(a)
(b)
F08617
(c)
If the backlash exceeds the maximum, replace the bearing.
(d)
If the deviation exceeds the maximum, replace the axle hub.
(e)
F02687
3.
(a)
(b)
(c)
(d)
SST
4.
F08616
− FRONT AXLE HUB
REMOVE FRONT WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
CHECK BEARING BACKLASH AND AXLE HUB DEVI-
ATION
Remove the 2 bolts, brake caliper and disc.
Support the brake caliper securely.
Using a dial indicator, check the backlash near the center
of the axle hub.
Maximum: 0.05 mm (0.0020 in.)
Using a dial indicator, check the deviation at the surface
of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 in.)
Install the disc, 2 bolts and brake caliper.
Torque: 107 N·m (1,090 kgf·cm, 79 ft·lbf)
REMOVE DRIVE SHAFT LOCK NUT
Using SST and a hammer, unstake the staked part of the
lock nut.
SST 09930−00010
While applying the brakes, remove the nut.
Torque: 216 N·m (2,200 kgf·cm, 159 ft·lbf)
Remove the brake caliper and disc.
Support the brake caliper securely.
w/ ABS:
REMOVE ABS SPEED SENSOR
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
1919
SA−13
SA1P1−02