Toyota Celica 2005 Repair Manual page 1938

Matchmarks
RH:
LH:
SST
SST
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
(2)
(3)
F04011
(4)
(5)
F04013
(e) Assemble the boot clamps to both boots.
(1)
(2)
Drive shaft standard length:
RH
LH
(3)
F02726
(4)
(5)
SST
(6)
NOTICE:
Do not overtighten the SST.
R10425
(7)
SST
Clearance: 1.2 − 4.0 mm (0.047 − 0.157 in.)
(8)
R10426
1937
− FRONT DRIVE SHAFT
Align the matchmarks on the inboard joint shaft and
outboard joint shaft.
Install the inboard joint shaft to the outboard joint
shaft.
Install a new snap ring.
Temporarily install the boot to the inboard joint
shaft.
Make sure that the boots are on the shaft grooves.
Make sure that the boots are not stretched or con-
tracted when the drive shaft is at standard length.
845.5 ± 5.0 mm (33.287 ± 0.197 in.)
563.7 ± 5.0 mm (22.193 ± 0.197 in.)
Bend the band and lock the inboard joint boot
clamps with a screwdriver.
Secure the 2 outboard joint boot clamps onto the
boot.
Place SST onto the outboard joint large boot clamp.
09521−24010
Tighten the SST so that the large clamp is pinched.
Using SST, adjust the clearance of the large clamp.
09240−00020
Employ the same manner to the outboard joint
small boot clamp.
SA−31