Toyota Celica 2005 Repair Manual page 2148

SUPPLEMENTAL RESTRAINT SYSTEM
Battery
Side Airbag
SST
Assembly
10 m (33 ft) or more
2005 CELICA (RM1131U)
(f)
Tires
(5 or More)
H01336
CAUTION:
Make sure that the wire harnesses are tight. It is very dan-
gerous when loose wire harnesses result in the tires com-
ing free due to the shock from the airbag deploying.
HINT:
Place the SST connector and wire harnesses inside tires. Se-
cure at least 1 m (3 ft) of slack for the wire harness.
R05403
(g)
NOTICE:
To avoid damaging the SST connector and wire harness,
do not lock the secondary lock of the twin lock. Also, se-
cure some slack for the SST wire harness inside the tire.
(h)
H01337
HINT:
The airbag deploys simultaneously as the LED of the SST ac-
tivation switch lights up.
(i)
CAUTION:
S
S
S
H00544
− SIDE AIRBAG ASSEMBLY
Place the tires.
(1) Place at least 2 tires under the tire to which the side
airbag assembly is tied.
(2) Place at least 2 tires over the tire to which the side
airbag assembly is tied. The top tire should have the
wheel installed.
(3) Tie the tires together with 2 wire harnesses.
Install the SST.
Connect the connectors of the 2 SST to the side airbag
assembly connector.
SST 09082−00700, 09082−00750
Deploy the airbag.
(1) Connect the SST red clip to the battery positive (+)
terminal and the black clip to the battery negative
(−) terminal.
(2) Check that no one is within 10 m (33 ft) area around
the tire which the side airbag assembly is tied to.
(3) Press the SST activation switch and deploy the air-
bag.
Dispose of the side airbag assembly.
The side airbag assembly is very hot when the airbag
is deployed, so leave it alone for at least 30 minutes
after deployment.
Use gloves and safety glasses when handling a side
airbag assembly with the deployed airbag.
Do not apply water etc. to a side airbag assembly with
the deployed airbag.
2147
RS−47