Toyota Celica 2005 Repair Manual page 1674

ST−8
Ohmmeter
Continuity
Ohmmeter
No
Continuity
ST0017 S00202
2005 CELICA (RM1131U)
STARTING − STARTER
7. INSPECT FIELD FRAME (FIELD COIL) FOR OPEN
CIRCUIT
Using an ohmmeter, check that there is continuity between the
lead wire and field coil brush lead.
If there is no continuity, replace the field frame.
S00212
8. INSPECT FIELD FRAME (FIELD COIL) GROUND
Using an ohmmeter, check that there is no continuity between
the field coil end and field frame.
If the is continuity, repair or replace the field frame.
S00201
9. INSPECT BRUSH LENGTH
Using vernier calipers, measure the brush length.
Standard length:
15.5 mm (0.610 in.)
Minimum length:
10.0 mm (0.394 in.)
If the length is less than minimum, replace the brush holder and
field frame.
B00532
10. INSPECT BRUSH SPRING LOAD
Take the pull scale reading the instant the brush spring sepa-
rates from the brush.
14 kW type
Standard spring installed load:
17.6 − 23.5 N (1.80 − 2.40 kgf, 4.0 − 5.3 Ibf)
Minimum spring installed load:
11.8 N (1.20 kgf, 2.6 Ibf)
1.2 kW type
ST0019
Standard spring installed load:
13.7 − 19.6 N (1.40 − 2.0 kgf, 3.1 − 4.6 lbf)
Minimum spring installed load:
8.8 N (0.9 kgf, 2.0 Ibf)
If the installed load is not within specification, replace the brush
springs.
1673