Toyota Celica 2005 Repair Manual page 1819

MX−46
Synchronizer
Middle Ring
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
HINT:
Take care not to damage the journal surface of the output shaft.
6.
7.
For 2nd Gear
(a)
(b)
(c)
NOTICE:
S
D07361
S
(d)
Synchronizer
Inner Ring
NOTICE:
Fit the synchronizer inner ring claws into the slots in the
No. 1 clutch hub.
D07362
(e)
NOTICE:
Be sure to install the 3rd driven gear in the correct direc-
tion, as shown in the illustration.
8.
D07363
− OUTPUT SHAFT
INSPECT 1ST GEAR THRUST CLEARANCE (See page
MX−39)
INSTALL SPACER, NEEDLE ROLLER BEARING, NO.2
SYNCHRONIZER RING, 2ND GEAR AND 3RD DRIVEN
GEAR
Install the spacer.
Apply gear oil to the needle roller bearing and install it.
Place the No. 2 synchronizer rings on the 2nd gear.
Properly fit the synchronizer middle ring claws into
the holes in the 2nd gear.
Distinguish the No. 2 synchronizer ring by the teeth
on the synchronizer ring.
Place the 2nd gear with the No. 2 synchronizer rings and
align the No. 2 synchronizer ring slots with the No. 1 shift-
ing keys.
Using a press, install the 3rd driven gear.
INSPECT 2ND GEAR THRUST CLEARANCE (See
page MX−39)
1818