Toyota Celica 2005 Repair Manual page 2152

SUPPLEMENTAL RESTRAINT SYSTEM
2005 CELICA (RM1131U)
− SIDE AIRBAG ASSEMBLY
3. INSTALL INNER FRONT SEAT CUSHION SHIELD
Install the inner front seat cushion shield with the screw.
H12635
4. INSTALL FRONT SEAT CUSHION SHIELD
5. INSTALL RECLINING ADJUSTER KNOB
6. INSTALL RECLINING ADJUSTER RELEASE HANDLE
7. INSTALL FRONT SEAT
NOTICE:
When mounting the seat to the vehicle, take care not to
damage the airbag wire harness.
(a) Connect the side airbag connector.
(b) Slide the front seat to the most front position.
H12634
NOTICE:
Make sure that seat adjuster locks.
(c) Without holding the seat track handle, mount the seat to
the vehicle.
HINT:
If holding the seat track handle, the adjusted rearmost position
slip off.
(d) Tighten the bolts on the front side temporarily, from the
bolt on the inner side tighten them completely.
Torque: 37 N·m (375 kgf·cm, 27 ft·lbf)
(e) Slide the seat to the most front position to install the bolts
on the rear side.
Torque: 37 N·m (375 kgf·cm, 27 ft·lbf)
(f) Install the 2 seat track covers.
2151
RS−51