BE−78
Wire harness side:
Tester connection
1 − Ground
5 − Ground
From back side:
Tester connection
3 − Ground
2 − Ground
2005 CELICA (RM1131U)
BODY ELECTRICAL
−
(g)
Disconnect the lead.
(h)
Set the battery (lithium battery) in the transmitter.
(i)
Install the cover, so that the O−ring is not distorted or
slipped off.
(j)
Using a screwdriver, tighten the screw.
3.
INSPECT WIRELESS DOOR LOCK CONTROL RE-
CEIVER CIRCUIT
(a)
Disconnect the connector from the receiver and inspect
the connector on the wire harness side as shown below.
I12038
Condition
Always
Always
If the circuit is not as specified, inspect the circuit connected to
other parts.
(b)
Connect the wire harness side connector to the receiver
and inspect the wire harness side connector from the
back side as shown below.
I12073
Condition
Normal mode
Ignition switch position OFF
Key removed
Transmitter ON
If circuit is as specified, replace the receiver.
If the circuit is not as specified, inspect the circuit connected to
other parts.
2252
WIRELESS DOOR LOCK CONTROL SYSTEM
Specified condition
Continuity
Battery voltage
Specified condition
10 − 14 V
About 6 − 7 V