Toyota Celica 2005 Repair Manual page 1794

2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
24.
25.
Using 2 screwdrivers and a hammer, tap out the snap ring.
D00307
26.
(a)
(b)
D00308
27.
A
Using a hexagon wrench, remove the 2 straight screw plugs.
B
D00309
28.
(a)
(b)
D00310
HINT:
FIPG
At the time of reassembly, please refer to the following item.
Apply FIPG to the transaxle case side, as shown in the illustra-
tion.
D07333
− MANUAL TRANSAXLE ASSEMBLY
REMOVE REVERSE IDLER GEAR SHAFT LOCK BOLT
AND GASKET
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
REMOVE SNAP RING FROM NO. 2 SHIFT FORK
SHAFT
REMOVE STRAIGHT SCREW PLUG, SEAT, SPRING
AND BALL
Using a hexagon wrench, remove the 3 straight screw
plugs.
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Using a magnetic finger, remove the 3 seats, springs and
balls.
REMOVE STRAIGHT SCREW PLUG
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque:
Plug A: 13 N·m (130 kgf·cm, 9 ft·lbf)
Plug B: 39 N·m (400 kgf·cm, 29 ft·lbf)
REMOVE TRANSMISSION CASE
Remove the 16 bolts.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
Carefully tap the transmission case with a plastic hammer
and remove it.
FIPG:
Part No. 08826−00090, THREE BOND 1281 or equiva-
lent
1793
MX−21