Toyota Celica 2005 Repair Manual page 2087

SST
Matchmarks
2005 CELICA (RM1131U)
STEERING
DISASSEMBLY
NOTICE:
When using a vise, do not overtighten it.
1.
Using SST, secure the PS gear assembly in a vise.
F09900
2.
Using SST, remove the 2 turn pressure tubes.
SST
F13581
3.
(a)
(b)
(c)
4.
F07501
(a)
(b)
NOTICE:
Be careful not to damage the boot.
HINT:
Mark the RH and LH rack boots.
(c)
5.
(a)
NOTICE:
Avoid any impact on the steering rack.
F09879
− POWER STEERING GEAR
SECURE PS GEAR ASSEMBLY IN VISE
SST 09612−00012
REMOVE 2 TURN PRESSURE TUBES
SST 09023−38201
REMOVE RH AND LH TIE ROD ENDS AND LOCK
NUTS
Place matchmarks on the tie rod end and rack end.
Loosen the lock nut, and remove the tie rod end and lock
nut.
Employ the same manner described above to the other
side.
REMOVE RH AND LH CLIPS, WIRES AND RACK
BOOTS
Using needle nose pliers, loosen the wire.
Remove the clip, wire and rack boot.
Employ the same manner described above to the other
side.
REMOVE RH AND LH RACK ENDS AND CLAW WASH-
ERS
Using a chisel and a hammer, unstake the washer.
2086
SR−41
SR0YS−03