Toyota Celica 2005 Repair Manual page 2371

10 Clips
B
Protective Tape
Adhesive Area
Adhesive Area
2005 CELICA (RM1131U)
BODY − BACK DOOR GLASS
REMOVAL
1. w/ Rear spoiler:
REMOVE REAR SPOILER
2. REMOVE REAR WIPER ARM
3. REMOVE DOOR PULL HANDLE
4. REMOVE BACK DOOR TRIM BOARD
Using a screwdriver, remove the back door trim board.
HINT:
Tape the screwdriver tip before use.
H12560
5. REMOVE CENTER STOP LIGHT
(a) Remove the 2 nuts.
(b) Disconnect the connector and washer hose, then remove
the center stop light in order A, B as shown in the illustra-
tion..
6. REMOVE BACK WINDOW OPENING TRIM
A
H12565
7. REMOVE BACK DOOR GLASS
(a) Insert a piano wire between body and glass and let it pass
through.
(b) Tie both wire ends to wooden blocks or similar object.
HINT:
Apply protective tape to the outer surface to keep the surface
from being scratched.
NOTICE:
When separating the glass, take care not to damage the
H12605
paint and exterior.
(c) Cut the adhesive by pulling the piano wire around it.
HINT:
Cut the adhesive areas as shown in the illustration.
H12606
2370
BO−65
BO2NW−02