Toyota Celica 2005 Repair Manual page 1731

2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
DISASSEMBLY
1.
2.
(a)
(b)
(c)
(d)
3.
4.
Remove the 2 bolts and control cable bracket.
5.
Remove the 2 nuts, wave washer and control shaft assembly.
D07393
6.
(a)
NOTICE:
At the time of reassembly, please refer to the following
item.
Fit the selecting bellcrank assembly pin part with the dust
cover into a groove in the control shift lever.
(b)
D07394
NOTICE:
At the time of reassembly, please refer to the following
item.
Apply MP grease to the inside circumferential surface of
the control bellcrank dust cover.
− MANUAL TRANSAXLE ASSEMBLY
REMOVE FILLER PLUG AND DRAIN PLUG WITH 2
GASKETS
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
REMOVE VEHICLE SPEED SENSOR
Remove the bolt and vehicle speed sensor.
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
Using a small screwdriver, remove the clip from the ve-
hicle speed sensor.
Remove the vehicle speed sensor driven gear from the
speed sensor.
Using a small screwdriver, remove the O−ring from the ve-
hicle speed sensor.
REMOVE BACK−UP LIGHT SWITCH WITH GASKET
Torque: 40 N·m (410 kgf·cm, 30 ft·lbf)
REMOVE CONTROL CABLE BRACKET
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
REMOVE CONTROL SHAFT ASSEMBLY
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
REMOVE SELECTING BELLCRANK ASSEMBLY
Remove the 2 bolts and selecting bellcrank assembly.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Remove the control bellcrank dust cover from the select-
ing bellcrank assembly.
1730
MX−13
MX09I−03