Toyota Celica 2005 Repair Manual page 1790

Hide thumbs Also See for Celica 2005:

Table of Contents

2005 CELICA (RM1131U)

MANUAL TRANSAXLE (C60)

MANUAL TRANSAXLE ASSEMBLY

Set SST to the rear radial ball bearing inner race securely,

drive in the bearing with a hammer.

Remove the spacer.

REMOVE INPUT SHAFT REAR RADIAL BALL BEAR-

ING AND 6TH GEAR

Using 2 screwdrivers and a hammer, tap out the snap

At the time of reassembly, please refer to the following item.

Select a snap ring from the table below that will make the thrust

clearance of the No. 3 clutch hub less than 0.1 mm (0.0039 in.).

Thickness mm (in.)

1.70 (0.0669)

1.75 (0.0689)

1.80 (0.0709)

1.85 (0.0728)

1.90 (0.0748)

1.95 (0.0768)

Using SST, remove the rear radial ball bearing and 6th

09950−40011 (09951−04010, 09952−04010,

09953−04030, 09954−04010, 09955−04021,

09957−04010, 09958−04011)

At the time of reassembly, please refer to the following item.

Set SST to the rear radial ball bearing inner race securely, drive

in the bearing with a hammer.

Remove the needle roller bearing and spacer.

Thickness mm (in.)

2.00 (0.0787)

2.05 (0.0807)

2.10 (0.0827)

2.15 (0.0846)

2.20 (0.0866)

2.25 (0.0886)

Show Quick Links

Table of Contents