Toyota Celica 2005 Repair Manual page 1791

MX−18
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
16.
NOTICE:
At the time of reassembly, please refer to the following
items.
For 6th Gear
S
S
D07697
17.
Remove the bolt, No. 3 gear shift fork and No. 3 hub sleeve.
D00299
18.
Using a dial indicator, measure the thrust clearance.
D00300
19.
Using a dial indicator, measure the radial clearance.
If the clearance exceeds the maximum, replace the gear,
needle roller bearing or shaft.
D00301
− MANUAL TRANSAXLE ASSEMBLY
REMOVE NO. 3 SYNCHRONIZER RING (FOR 6TH
GEAR)
Align the No. 3 synchronizer ring slots with the No. 3
shifting keys.
Distinguish the No. 3 synchronizer ring (for the 6th
gear) by the teeth on the synchronizer ring.
REMOVE NO. 3 GEAR SHIFT FORK AND NO. 3 HUB
SLEEVE
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 16 N·m (160 kgf·cm, 12 ft·lbf)
INSPECT 5TH GEAR THRUST CLEARANCE
Standard clearance:
0.10 − 0.62 mm (0.0039 − 0.0244 in.)
Maximum clearance:
0.62 mm (0.0244 in.)
INSPECT 5TH GEAR RADIAL CLEARANCE
Standard clearance:
0.015 − 0.056 mm (0.0006 − 0.0022 in.)
Maximum clearance:
0.056 mm (0.0022 in.)
1790