Toyota Celica 2005 Repair Manual page 1932

Matchmarks
Matchmarks
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
(2)
NOTICE:
Do not punch the marks.
(3)
(d) Remove the tripod.
(1)
FA1615
(2)
NOTICE:
Do not punch the marks.
(3)
NOTICE:
Do not tap the roller.
(e) Remove the inboard and outboard joint boots and in-
N00194
board joint clamps.
NOTICE:
Do not disassemble the out board joint.
3. DISASSEMBLE INBOARD JOINT SHAFT
SST
(a) LH:
Remove the dust cover.
Using SST and a press, remove the dust cover.
SST
(b) LH shaft of 1ZZ−FE engine (M/T) and 2ZZ−GE engine:
Using a snap ring expander, remove the outer snap ring.
R09716
(c) RH:
Remove the transaxle side dust cover.
Using a press, remove the transaxle side dust cover.
Z03002
− FRONT DRIVE SHAFT
Place matchmarks on the inboard joint shaft, tripod
and outboard joint shaft.
Remove the inboard joint shaft from the outboard
joint shaft.
Using a snap ring expander, remove the snap ring.
Place matchmarks on the outboard joint shaft and
tripod.
Using a brass bar and hammer, remove the tripod
from the outboard joint shaft.
09950−00020
1931
SA−25