Toyota Celica 2005 Repair Manual page 1936

RH:
LH:
SST
SST
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
(e)
Drive shaft standard length:
F02726
NOTICE:
Do not overtighten the SST.
R10425
R10426
3.
Vinyl Tape
(a)
HINT:
Before installing the boots, wrap the spline of the outboard joint
shaft with vinyl tape to prevent them from being damaged.
W01994
− FRONT DRIVE SHAFT
Assemble the boot clamps to both boots.
(1) Make sure that the boots are on the shaft grooves.
(2) Make sure that the boots are not stretched or con-
tracted when the drive shaft is at standard length.
RH 851.0 ± 5.0 mm (33.504 ± 0.197 in.)
LH 565.9 ± 5.0 mm (22.279 ± 0.197 in.)
(3) Bend the band and lock the inboard joint boot
clamps with a screwdriver.
(4) Secure the 2 outboard joint boot clamps onto the
boot.
(5) Place SST onto the outboard joint large boot clamp.
SST 09521−24010
(6) Tighten the SST so that the large clamp is pinched.
(7) Using SST, adjust the clearance of the large clamp.
SST 09240−00020
Clearance: 0.8 mm (0.031 in.) or less
(8) Employ the same manner to the outboard joint
small boot clamp.
1ZZ−FE engine (M/T) and 2ZZ−GE engine:
REASSEMBLE DRIVE SHAFT
Temporarily install dynamic damper (M/T), new outboard
and inboard joint boots and new clamps.
(1) Place 2 new clamps on a new outboard joint boot
and install them to the outboard joint shaft.
(2) M/T:
Place new clamp on the dynamic damper and install
them to the outboard joint shaft.
(3) Place 2 new clamps on a new inboard joint boot and
install them to the outboard joint shaft.
1935
SA−29