SA−30
Matchmarks
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
(b)
Assemble the outboard joint shaft.
(1)
NOTICE:
The side with smaller diameter must face outboard joint.
(2)
R03118
(3)
NOTICE:
Be careful not to damage the inner race.
R03036
(4)
F02793
(5)
(6)
(7)
HINT:
Apply grease onto the balls to keep them from falling.
(c)
Install the boot to outboard joint.
Before assembling the boot, pack the outboard joint and
boot with grease in the boot kit.
Grease capacity: (Color = Black)
R03004
115 − 135 g (4.1 − 4.8 oz.)
(d)
Install the inboard joint shaft to outboard joint shaft.
(1)
Grease capacity: (Color = Gray)
100 − 120 g (3.5 − 4.2 oz.)
1936
−
FRONT DRIVE SHAFT
Install the cage to the outboard joint shaft.
Align the matchmarks on the inner race and out-
board joint shaft.
Using a brass bar and hammer, tap in the inner race
to the outboard joint shaft.
Using a snap ring expander, install a new snap ring.
Align the matchmarks on the cage and inner race.
Install the cage to the inner race.
Install the 6 balls.
Before assembling the boot, pack the inboard joint
and boot with grease in the boot kit.