Toyota Celica 2005 Repair Manual page 1914

1
2
A
D
Front
C
2005 CELICA (RM1131U)
SUSPENSION AND AXLE
(e) Adjust the camber by pushing or pulling the lower side of
the shock absorber in the direction in which the camber
adjustment is required.
(f) Tighten the nuts.
Torque: 153 N·m (1,560 kgf·cm, 113 ft·lbf)
(g) Install the front wheel.
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
(h) Check the camber.
HINT:
Try to adjust the camber to the center of the specified val-
S
ue.
Adjusting value for the set bolts is 6' − 30' (0.1° − 0.5°).
S
If the camber is not within the specified value, using the follow-
ing table, estimate how much additional camber adjustment will
be required, and select the camber adjusting bolt.
Bolt
F04048
Adjusting
Value
15'
30'
45'
1°00'
1°15'
1°30'
(i) Do the steps mentioned above again. Between step (b)
and (c), replace 1 or 2 selected bolts.
HINT:
When replacing the 2 bolts, replace 1 bolt for each time.
5. INSPECT TOE−IN
B
Toe−in:
Toe−in
(total)
If the toe−in is not within the specified value, adjust it at the rack
ends.
6. ADJUST TOE−IN
(a) Remove the rack boot set clips.
SA3213
1913
− FRONT WHEEL ALIGNMENT
Set Bolt
90105−15001 90105−15004 90105−15005
1 Dot
1 2 1
A + B: 0° ± 12' (0° ± 0.2°)
C − D: 0 ± 2 mm (0 ± 0.08 in.)
Adjusting Bolt
90105−15006
3 Dots
2 Dots
2 1 2 1
SA−7
2
F01195