Toyota Celica 2005 Repair Manual page 2251

BE−76
2005 CELICA (RM1131U)
BODY ELECTRICAL − WIRELESS DOOR LOCK CONTROL SYSTEM
INSPECTION
1. INSPECT WIRELESS DOOR LOCK TRANSMITTER
OPERATION
HINT:
Refer to "Wireless door lock control receiver and transmitter re-
placement" on page BE−79.
(a) Using a screwdriver, remove the screw and the cover.
(b) Remove the battery (lithium battery).
(c) Install a new or normal battery (lithium battery).
HINT:
When a new or normal battery can not be obtained, connect 2
new 1.5 V batteries in series, and connect the battery (+) to the
battery receptacle side terminal and battery (−) to the bottom
terminal, then apply 3 V voltage to the transmitter.
(d) In the location approx. 1 M away from driver's outside
handle in the right direction, check the transmitter opera-
tion as pressing transmission switch on the surface of the
N30015
transmitter body.
Standard:
Remote control of the vehicle door lock can be operated.
HINT:
The minimum operation distance differs depending on
S
the operator, the way of holding the transmitter, and loca-
tion.
As the transmitter uses weak wave, its operating range
S
becomes narrowed when the weak wave is interrupted by
noise.
(e) Install the battery (lithium battery).
(f) Install the cover so that O−ring is not distorted or slipped
off.
(g) Using a screwdriver, tighten the screw.
2250
BE0OJ−15