Toyota Celica 2005 Repair Manual page 1676

ST−10
SST
Wear
2005 CELICA (RM1131U)
STARTING −
REPLACEMENT
1. INSPECT BEARING
Turn the bearing by hand while applying inward force.
If resistance is felt or if the sticks, replace the bearing.
ST0041
2. REPLACE BEARINGS
(a) Using SST, remove the bearing.
SST
P01052
(b) Using SST and a press, press in a new front bearing.
SST
(c) Using a press, press in a new rear bearing.
3. REMOVE MAGNETIC SWITCH END COVER
(a) Remove the 3 bolts, end cover, gasket and plunger.
P00485
(b) Inspect the contact plate for wear.
Using vernier calipers, measure the contact plate for
depth of wear.
Maximum wear: 0.9 mm (0.035 in.)
If the depth of wear is greater than the maximum, replace the
contact plate.
B00230
(c) Remove the terminal kit parts.
(1)
SST
(2)
SST
B00410
1675
STARTER
09286−46011
09820−00031
Using SST, loosen the terminal nuts.
09810−38140
Terminal C:
Remove the terminal nut,wave washer, terminal in-
sulator (outside), O−ring, terminal bolt, contact
plate and terminal insulator (inside).
ST0FQ−09