Toyota Celica 2005 Repair Manual page 1980

2005 CELICA (RM1131U)
SUSPENSION AND AXLE
F08627
Matchmarks
F08628
− REAR LOWER SUSPENSION ARM
REMOVAL
1. REMOVE REAR WHEEL
Torque: 103 N·m (1,050 kgf·cm, 76 ft·lbf)
2. REMOVE ABS SPEED SENSOR WIRE HARNESS
CLAMP
Remove the bolt and disconnect the ABS speed sensor wire
harness clamp.
Torque: 19 N·m (194 kgf·cm, 14 ft·lbf)
3. REMOVE TAILPIPE
Remove the 2 bolts, springs, gasket, 3 O−rings and tailpipe.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
4. DISCONNECT PARKING BRAKE CABLE CLAMP
Remove the 2 bolts and disconnect the parking brake cable
clamps.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
5. LOOSEN 3 BOLTS ON FRONT SIDE OF LOWER SUS-
PENSION ARM
Torque: 65 N·m (663 kgf·cm, 48 ft·lbf)
HINT:
Do not remove the bolts.
S
At the time of installation, after stabilizing the suspension,
S
torque the bolts.
6. DISCONNECT REAR AXLE CARRIER FROM LOWER
SUSPENSION ARM
(a) Remove the front side bolt and nut.
Torque: 74 N·m (755 kgf·cm, 55 ft·lbf)
HINT:
At the time of installation, after stabilizing the suspension,
torque the nut.
(b) Place matchmarks on both the cam plate and lower sus-
pension arm.
1979
SA−73
SA1PG−02