Toyota Celica 2005 Repair Manual page 1859

AX−26
2005 CELICA (RM1131U)
AUTOMATIC TRANSAXLE (U240E)
6.
(a)
(b)
(c)
(d)
(e)
D05932
(f)
7.
(a)
(b)
(c)
D05931
8.
(a)
(b)
D05930
(c)
(d)
(e)
HINT:
Coat the threads of screws with sealant.
D05929
NOTICE:
Make sure not to catch O/D main switch wire harness.
9.
(a)
(b)
− FLOOR SHIFT ASSEMBLY
INSTALL LOWER POSITION INDICATOR HOUSING
Apply MP grease on the spring.
Install the spring and shift lock release button.
Install the indicator lamp wire sub−assembly with the
screw.
Install the bulb and bulb cap to the indicator lamp wire
sub−assembly.
Install the lower position indicator housing with the 4
screws.
Install the indicator lamp wire sub−assembly.
INSTALL UPPER POSITION INDICATOR HOUSING
Install the 4 slide covers to the lower position indicator
housing, as shown in the illustration.
Install the control position indicator plate.
Install the upper position indicator housing.
INSTALL SHIFT LEVER KNOB SUB−ASSEMBLY
Apply MP grease on the compression spring.
Install the compression spring, shift lever knob button
guide, shift lever knob button and shift lever stop pin.
Install the No. 2 slide cover.
Install the O/D main switch.
Install the shift lever knob sub−assembly with the 2
screws.
Sealant:
Part No. 08833−00080, THREE BOND 1344, LOCTITE
242 or equivalent
INSTALL O/D MAIN SWITCH TERMINAL
Connect the 2 O/D main switch terminals to the connec-
tor.
Connect the connector to the shift lever plate.
1858