Toyota Celica 2005 Repair Manual page 1470

EM−84
2005 CELICA (RM1131U)
ENGINE MECHANICAL
A10431
Grommet
A21008
A
B
D07380
− ENGINE UNIT
(c) Install the upper heat insulator with the 4 bolts.
Torque: 20 N·m (204 kgf·cm, 15 ft·lbf)
11. INSTALL EXHAUST PIPE
(a) Install new 2 gaskets and exhaust pipe.
(b) Connect the 2 O−rings.
(c) Install the 4 springs and bolts.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
(d) Connect the 2 heated oxygen sensors.
(See page EM−117)
12. INSTALL DRIVE SHAFT (See page SA−33)
13. CONNECT 2 GROUND CABLES
14. CONNECT TRANSAXLE CONTROL CABLE (S)
15. M/T:
CONNECT CLUTCH RELEASE CYLINDER
(a) Install the release cylinder with the 2 bolts.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
(b) Install the brackets with the 3 bolts.
Torque:
Bolt A 12 N·m (120 kgf·cm, 9 ft·lbf)
Bolt B 4.9 N·m (50 kgf·cm, 43 in.·lbf)
16. CONNECT TUBE AND HOSE
(a) Connect the brake booster vacuum hose.
(b) Connect the 2 heater hoses to the engine side.
(c) Connect the fuel tube to the fuel pipe on vehicle side.
1469