Toyota Celica 2005 Repair Manual page 2261

BE−86
Wire Harness Side
Tester connection
1 − Ground
2 − Ground
2 − Ground
5 − Ground
7 − Ground
6 − Ground
8 − Ground
8 − Ground
9 − Ground
9 − Ground
10 − Ground
10 − Ground
2005 CELICA (RM1131U)
BODY ELECTRICAL
INSPECTION
1.
If continuity is not as specified, replace the switch.
8 4 3
I01678
2.
Disconnect the connector from the ECU and inspect the con-
nector on the wire harness side, as shown in the chart.
I04045
Constant
Ignition switch LOCK or ACC
Ignition switch ON
Constant
Constant
Constant
Ignition switch LOCK or ACC
Ignition switch ON
Sliding roof control switch CLOSE/DOWN
Sliding roof control switch OPEN/UP
Sliding roof control switch OPEN/UP
Sliding roof control switch CLOSE/DOWN
*: Exceptions: Within 43 seconds after the ignition switch ON →
OFF (ACC) or until driver or passenger door is opened after the
ignition switch ON → OFF (ACC).
If the circuit is not as specified, replace the assembly.
− SLIDING ROOF SYSTEM
INSPECT SLIDING ROOF SWITCH CONTINUITY
Switch position
OPEN
OFF
CLOSE
INSPECT SLIDING ROOF CONTROL ASSEMBLY CIR-
CUIT
Condition
2260
Tester connection Specified condition
3 − 8
−
4 − 8
Specified condition
Continuity
No voltage*
Battery positive voltage
Battery positive voltage
Continuity
No continuity
No voltage
Battery positive voltage
No continuity
Continuity
No continuity
Continuity
BE1DA−05
Continuity
No continuity
Continuity