Toyota Celica 2005 Repair Manual page 1778

B
SST
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
9.
(a)
A
(b)
D07380
10.
(a)
(b)
(c)
D07383
11.
(a)
(b)
D07391
12.
13.
14.
D07392
15.
Using SST, disconnect the pressure feed and return tubes.
HINT:
S
S
F13580
− MANUAL TRANSAXLE UNIT
DISCONNECT CLUTCH RELEASE CYLINDER
Remove the 4 set bolts of the clutch line.
Torque:
Bolt A: 12 N·m (120 kgf·cm, 9 ft·lbf)
Bolt B: 4.9 N·m (50 kgf·cm, 43 in.·lbf)
Remove the 2 set bolts of the clutch release cylinder and
clutch line bracket.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
REMOVE STARTER
Disconnect the starter connector.
Remove the nut and disconnect the starter wire.
Remove the 2 bolts and starter.
Torque: 37 N·m (378 kgf·cm, 28 ft·lbf)
REMOVE CONTROL CABLE BRACKET
Disconnect the wire harness from the clamp.
Remove the 2 bolts, clamp and control cable bracket from
the transaxle.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
REMOVE 2 TRANSAXLE UPPER SIDE MOUNTING
BOLTS
Torque: 64 N·m (650 kgf·cm, 47 ft·lbf)
DISCONNECT RH AND LH TIE ROD ENDS (See page
SA−13)
DISCONNECT NO. 2 INTERMEDIATE SHAFT AS-
SEMBLY (See page SR−13)
DISCONNECT PRESSURE FEED AND RETURN
TUBES
SST 09023−38400
Torque: 40 N·m (410 kgf·cm, 30 ft·lbf)
Use torque wrench with a fulcrum length of 345 mm
(13.58 in.).
This torque value is effective in case that SST is parallel
to a torque wrench.
1777
MX−5