Toyota Celica 2005 Repair Manual page 1789

MX−16
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
13.
Using a dial indicator, measure the radial clearance.
If the clearance exceeds the maximum, replace the gear,
needle roller bearing or shaft.
D00290
14.
(a)
HINT:
At the time of reassembly, please refer to the following item.
Select a snap ring from the table below that will make the thrust
clearance of the output shaft rear radial ball bearing less than
0.1 mm (0.0039 in.).
D06026
Mark
B
C
D
E
F
G
(b)
SST
D06027
HINT:
At the time of reassembly, please refer to the following items.
S
SST
NOTICE:
Be sure to install the 6th driven gear in the correct direc-
tion, as shown in the illustration.
D06028
− MANUAL TRANSAXLE ASSEMBLY
INSPECT 6TH GEAR RADIAL CLEARANCE
Standard clearance:
0.009 − 0.050 mm (0.0003 − 0.0020 in.)
Maximum clearance:
0.050 mm (0.0020 in.)
REMOVE OUTPUT SHAFT REAR RADIAL BALL
BEARING, 6TH DRIVEN GEAR AND SPACER
Using 2 screwdrivers and a hammer, tap out the snap
ring.
Thickness mm (in.)
2.31 (0.0909)
2.37 (0.0933)
2.43 (0.0957)
2.49 (0.0980)
2.55 (0.1004)
2.61 (0.1028)
Using SST, remove the rear radial ball bearing and 6th
driven gear.
SST 09950−40011 (09951−04010, 09952−04010,
09953−04030, 09954−04010, 09955−04021,
09957−04010, 09958−04011)
Using SST and a hammer, drive in the 6th driven gear.
SST 09325−12010
1788
Mark Thickness mm (in.)
H 2.67 (0.1051)
J 2.73 (0.1075)
K 2.79 (0.1098)
L 2.85 (0.1122)
M 2.91 (0.1146)
− −