Toyota Celica 2005 Repair Manual page 1454

EM−68
180°
Front
Painted Mark
6 2
9
9
9
5 1
2005 CELICA (RM1131U)
ENGINE MECHANICAL
(e)
A21009
(f)
(g)
(h)
A01464
3.
(a)
A01461
(b)
HINT:
S
S
(c)
A01462
(d)
4 8
3 7
A12962
− CYLINDER HEAD
2ZZ−GE:
Retighten the cylinder head bolts 180° in the numerical
order shown and check that the paint mark is not at a 180°
angle to the front.
Install the bolt holding the water bypass pipe to the cylin-
der head.
Torque: 9.0 N·m (92 kgf·cm, 80 in.·lbf)
Connect the upper radiator hose to the water hose
unions.
Connect the heater hose to the water hose unions.
INSTALL CAMSHAFTS
Place the 2 camshafts on the cylinder head with the No.
1 cam lobes facing as shown the illustration.
Install the bearing caps in their proper locations.
1ZZ−FE:
No. 3 camshaft bearing cap has a number and front mark.
2ZZ−GE:
No. 2, No.3 camshaft bearing cap has a number and front
mark.
Apply a light coat of engine oil on the threads and under
the heads of the bearing cap bolts.
1ZZ−FE:
Install and uniformly tighten the 19 bearing cap bolts.
After tightening the No. 1 camshaft bearing cap, tighten
them in several passes, in the sequence shown.
Torque:
No. 1 23 N·m (235 kgf·cm, 17 ft·lbf)
No. 3 13 N·m (133 kgf·cm, 10 ft·lbf)
1453