Toyota Celica 2005 Repair Manual page 1512

Air
A
Pinch
Pinch
Air Drain Port
2005 CELICA (RM1131U)
EMISSION CONTROL
Air Inlet Line Hose
B08764
B00658
B08765
Purge Port
Vent Port
Cap
EVAP Port
Air
B08766
− EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
8. CHECK AIR INLET LINE
(a) Disconnect the air inlet line hose from the charcoal canis-
ter.
(b) Check that there is ventilation in the air inlet line.
(c) Reconnect the air inlet line hose to the charcoal canister.
9. REMOVE CHARCOAL CANISTER ASSEMBLY
(a) Disconnect the VSV connector.
(b) Disconnect the purge line hose, EVAP line hose and air
inlet line hose from the charcoal canister.
(c) Disconnect the vent line hose from charcoal canister.
(1) Push the connector deep inside.
(2) Pinch portion A.
(3) Pull out the connector.
(d) Remove the 3 nuts and charcoal canister assembly.
10. INSPECT CHARCOAL CANISTER
(a) Visually check the charcoal canister for cracks or dam-
age.
HINT:
Be sure to check the areas indicated by the allow marks. These
areas are especially prone to cracking.
(b) Inspect the charcoal canister operation.
(1) Plug the vent port with a cap.
(2) While holding the purge port closed, blow air (1.76
kPa, 18 gf/cm
check that air flows from the air drain port.
1511
2
, 0.26 psi) into the EVAP port and
EC−9