Toyota Celica 2005 Repair Manual page 1692

SST (C)
Turn
SST (B)
Wire Clip
2005 CELICA (RM1131U)
CHARGING
SST (A)
B00237
Turn
SST (A)
B00322
B07735
SST
B09160
− GENERATOR
(e) To loosen the pulley nut, turn SST (A) in the direction
shown in the illustration.
NOTICE:
To prevent damage to the rotor shaft, do not loosen the
pulley nut more than one−half of a turn.
(f) Remove the generator from SST (C).
(g) Turn SST (B), and remove SST (A and B).
(h) Remove the pulley nut and pulley.
5. REMOVE RECTIFIER END FRAME
(a) Remove the 4 nuts and wire clip.
(b) Using SST, remove the rectifier end frame.
SST 09286−46011
(c) Remove the generator washer from the rotor
6. REMOVE ROTOR FROM DRIVE END FRAME
1691
CH−9