SR−50
SST
SST
Punch
2005 CELICA (RM1131U)
STEERING
(b)
(c)
10.
(a)
(b)
(c)
12°
F09891
(d)
(e)
F09892
(f)
F09893
(g)
(h)
(i)
F09923
−
POWER STEERING GEAR
Apply sealant to 2 or 3 threads of the rack guide spring
cap.
Sealant:
Part No. 08833−00080, THREE BOND 1344,
LOCTITE 242 or equivalent
Temporarily install the rack guide spring cap.
ADJUST TOTAL PRELOAD
To prevent the steering rack teeth from damaging the oil
seal lip, temporarily install the RH and LH rack ends.
Torque the rack guide spring cap.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Return the rack guide spring cap 12°.
Using SST, turn the control valve shaft right and left 1 or
2 times.
SST
09616−00011
Loosen the rack guide spring cap until the rack guide
spring is not functioning.
Using SST and torque wrench, tighten the rack guide
spring cap until the preload is within the specification.
SST
09616−00011
Preload (turning):
0.9 − 1.3 N·m (9 − 13 kgf·cm, 8.0 − 11.5 in.·lbf)
Using a punch and a hammer, stake 2 parts in opposing
positions on the rack guide spring cap.
Recheck the total preload.
Preload (turning):
0.9 − 1.3 N·m (9 − 13 kgf·cm, 8.0 − 11.5 in.·lbf)
Remove the RH and LH rack ends.
2095