Toyota Celica 2005 Repair Manual page 2359

A
A
2005 CELICA (RM1131U)
BODY − WINDSHIELD
(c) Correct insufficient or protruded adhesive agent using a
spatula.
HINT:
Apply the adhesive agent up to the windshield glass edge.
H00679
(d) Install a new windshield moulding to the windshield glass
before the adhesive agent hardens.
HINT:
Install the moulding, aligning the center of moulding with the
center of body.
(e) Remove any excessive adhesive agent before it hardens.
(f) Hold the glass and moulding in place securely with a pro-
tective tape or equivalent until the adhesive hardens.
NOTICE:
H03003
Take care not to drive the vehicle during the time described
in the table below.
Temperature
35 °C (95 °F)
20 °C (68 °F)
5 °C (41 °F)
12. INSPECT FOR LEAK AND REPAIR
NOTICE:
Conduct a leak test after the hardening time has elapsed.
13. INSTALL FRONT SIDE OF ROOF HEADLINING
14. INSTALL COWL TOP VENTILATOR LOUVER
HINT:
Check that the 2 clips on the back side of the cowl louver are
surely fixed to the body.
15. INSTALL HOOD TO COWL TOP SEAL
16. INSTALL WIPER ARMS
(a) Operate the wiper motor once and turn the wiper switch
OFF.
(b) Install the wiper arms and tighten the nuts by hand.
(c) Adjust the installation positions of the wiper arms to the
positions as shown in the illustration.
A: 30 ± 7.5 mm (1.8 ± 0.295 in.)
(d) Torque the nuts.
Torque: 32 N·m (323 kgf·cm, 23 ft·lbf)
(e) Install the 2 wiper arm head caps.
H12666
2358
Minimum time prior to driving the vehicle
1.5 hours
5 hours
24 hours
BO−53