Toyota Celica 2005 Repair Manual page 2095

Vinyl Tape
SST
2005 CELICA (RM1131U)
STEERING
4. INSTALL OIL SEAL
(a) Coat a new oil seal lip with power steering fluid.
(b) To prevent oil seal lip damage, wind vinyl tape on the
steering rack end, and apply power steering fluid.
(c) Install the oil seal by pushing it into the rack housing with-
out tilting.
NOTICE:
Make sure that the oil seal is installed facing in the
S
correct direction.
F09888
Be careful not to damage the oil seal lip.
S
5. INSTALL CYLINDER END STOPPER
(a) Using SST and a hammer, drive in the cylinder end stop-
per.
SST
(b) Using snap ring pliers, install a new snap ring to the rack
SST
housing.
F09922
6. AIR TIGHTNESS TEST
(a) Install SST to the rack housing.
SST
(b) Apply 53 kPa (400 mmHg, 15.75 in.Hg) of vacuum for
about 30 seconds.
(c) Check that there is no change in the vacuum.
If there is a change in the vacuum, check the installation of the
oil seals.
7. INSTALL CONTROL VALVE ASSEMBLY
F09889
NOTICE:
Be careful not to damage the teflon rings and oil seal lips.
8. INSTALL RACK HOUSING CAP
(a) Coat a new O−ring with power steering fluid, and install
it to the rack housing cap.
(b) Install the rack housing cap.
Torque: 74 N·m (750 kgf·cm, 54 ft·lbf)
9. INSTALL RACK GUIDE SUB−ASSEMBLY, CONICAL
SPRING WASHER AND RACK GUIDE SPRING CAP
(a) Install the rack guide sub−assembly and conical spring
washer.
F09890
− POWER STEERING GEAR
09612−22011
09631−12071
2094
SR−49