Toyota Celica 2005 Repair Manual page 1725

Filler Plug
Drain Plug
E
A
C
Nut
D
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
22.
23.
Oil Level
0 − 5 mm
(0 − 0.02 in.)
24.
(a)
D07382
HINT:
At the time of installation, please refer to the following items.
S
S
(b)
(c)
25.
26.
(a)
(b)
27.
Remove the bolt (bolt A) and 3 nuts, and disconnect the engine
rear mount insulator and front suspension member.
28.
B
Remove the 2 bolts (bolt B) and disconnect the engine front
mount insulator and front suspension member.
29.
C
Using a transmission jack, support the front suspension mem-
ber with lower suspension arm.
30.
D
Remove the 6 bolts (bolt C, D and E) and front suspension
member with lower suspension arm and PS gear assembly.
D10562
− MANUAL TRANSAXLE UNIT
DRAIN TRANSAXLE OIL
Oil grade: API GL−4 or GL−5
Viscosity: SAE 75W−90
Capacity: 1.9 liters (2.0 US qts, 1.7 Imp. qts)
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
REMOVE LH AND RH FRONT DRIVE SHAFTS
(See page SA−19)
REMOVE FRONT EXHAUST PIPE
Disconnect the 2 heated oxygen sensors.
Torque: 44 N·m (450 kgf·cm, 33 ft·lbf)
Before installing the heated oxygen sensor, twist the sen-
sor wire counterclockwise 3 and 1/2 turns.
After installing the heated oxygen sensor, check that the
sensor wire is not twisted. If it is twisted, remove the
heated oxygen sensor and reinstall it.
Remove the 4 bolts, compression springs and 2 gaskets.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
Disconnect the front exhaust pipe from the pipe supports
and remove it.
DISCONNECT LOWER BALL JOINT FROM LOWER
SUSPENSION ARM (See page SA−43)
DISCONNECT STABILIZER BAR LINK
Remove the nut and disconnect the stabilizer bar link.
Torque: 44 N·m (450 kgf·cm, 33 ft·lbf)
Employ the same manner described above to the other
side.
DISCONNECT ENGINE REAR MOUNT INSULATOR
AND FRONT SUSPENSION MEMBER
Torque: 52 N·m (530 kgf·cm, 38 ft·lbf)
DISCONNECT ENGINE FRONT MOUNT INSULATOR
AND FRONT SUSPENSION MEMBER
Torque: 52 N·m (530 kgf·cm, 38 ft·lbf)
SUPPORT FRONT SUSPENSION MEMBER WITH
LOWER SUSPENSION ARM
REMOVE FRONT SUSPENSION MEMBER WITH LOW-
ER SUSPENSION ARM AND PS GEAR ASSEMBLY
1724
MX−7