Toyota Celica 2005 Repair Manual page 1800

Plastic Hammer
SST
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C60)
(e)
SST
NOTICE:
Be sure to install a new bearing in the correct direction, as
shown in the illustration.
(f)
D00325
6.
Install the transaxle case receiver to the transaxle case with the
bolt.
7.
(a)
Extension Bar
NOTICE:
Socket Wrench
When driving out the bushing, be careful not to damage the
transmission case by the socket wrench.
D07349
(b)
0.80 − 1.30 mm
D07350
8.
(a)
D07352
− MANUAL TRANSAXLE ASSEMBLY
Using SST and a press, install a new output shaft front
bearing.
SST 09950−60010 (09951−00560), 09950−70010
(09951−07150)
Install the bearing lock plate with the bolt.
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
INSTALL TRANSAXLE CASE RECEIVER
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
IF NECESSARY, REPLACE TRANSMISSION CASE
BUSHING
Using a socket wrench (12 mm), extension bar and plastic
hammer, drive out the bushing.
Using SST and a hammer, drive in a new bushing.
SST 09950−60010 (09951−00180), 09950−70010
(09951−07100)
Drive in depth: 0.80 − 1.30 mm (0.0315 − 0.0512 in.)
IF NECESSARY, REPLACE TRANSMISSION CASE
OIL SEAL
Using a screwdriver and hammer, drive out the oil seal.
1799
MX−27