Toyota Celica 2005 Repair Manual page 1734

MX−16
Wooden Block
SST
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
S
D08259
S
NOTICE:
S
S
Engine Side
D04556
13.
Using a dial indicator, measure the thrust clearance.
Q02519
14.
Using a dial indicator, measure the radial clearance.
Z00658
If the clearance exceeds the maximum, replace the gear,
needle roller bearing or shaft.
− MANUAL TRANSAXLE ASSEMBLY
Before driving in the No. 3 clutch hub assembly, place the
suitable sized wooden block on the rear side of the input
shaft, as shown in the illustration. When driving it in, fix the
input shaft firmly so that it is not pushed downward. Other-
wise the input shaft rear radial ball bearing is overloaded,
it might be damaged.
Using SST and a hammer, drive in the No. 3 hub sleeve
assembly with the No. 3 gear shift fork.
SST 09636−20010
Be sure to install the No. 3 hub sleeve assembly in the
correct direction, as shown in the illustration.
Align the No. 3 synchronizer ring slots with the No. 3
shifting keys.
INSPECT 5TH GEAR THRUST CLEARANCE
Standard clearance:
0.10 − 0.57 mm (0.0039 − 0.0224 in.)
Maximum clearance:
0.57 mm (0.0224 in.)
INSPECT 5TH GEAR RADIAL CLEARANCE
Standard clearance:
KOYO made:
0.015 − 0.058 mm (0.0006 − 0.0023 in.)
NSK made:
0.015 − 0.056 mm (0.0006 − 0.0022 in.)
Maximum clearance:
KOYO made: 0.058 mm (0.0023 in.)
NSK made: 0.056mm (0.0022 in.)
1733